My Store
Classic Log & Lumber End Sealer - Water Based Wax Emulsion, Prevents up to 90% of End Checking on Cut Ends of Hardwood & Softwood … (1 Gallon)
Classic Log & Lumber End Sealer - Water Based Wax Emulsion, Prevents up to 90% of End Checking on Cut Ends of Hardwood & Softwood … (1 Gallon)
Couldn't load pickup availability
- Prevents up to 90% of end checking (drying splits), improves yield with less waste
- Reduces blue stain and sapstain in logs
- Water-based, Non-hazardous, No solvents, soap & water clean-up
- ANCHORSEAL has been the #1 log and lumber end grain sealer since 1980
- For hardwood & softwood logs & lumber, Debarked logs, Log exports, Wood-turning blanks, Log "cookies
Product Description
ANCHORSEAL Classic is a best-in-class premium wax emulsion end sealer used for the prevention of end checks (drying splits) in both hardwood & softwood logs or lumber. By controlling the rate of moisture loss, up to 90% of end checks can be prevented when applying ANCHORSEAL. It was the 1st end grain sealer introduced to the log & lumber industry by U-C Coatings in 1980 and is still considered the best end grain protection you can get for logs & lumber. It is also widely used in the woodworking industry to protect, debarked logs, wood turning blanks, log "cookies" and live edge slabs.
Features:
• Prevents up to 90% of end checks and drying splits on logs and freshly cut lumber • Can be applied to all species of hardwood or softwood
• Helps prevent blue stain and sapstain caused by damaging fungi • Water based, non-hazardous, no solvents, soap & water clean-up • Available in clear or more than 35 colors • Winterized formulas available
Coverage: 100 sq. ft./gallon, depending on application method and wood species.
Surface Preparation
- All areas to be coated should be clear of dirt and debris
Application
- Apply ANCHORSEAL using a brush, roller or sprayer until it begins to drip slightly
- For optimal coverage, use a gas engine, electric, air operated or backpack sprayer
- If using spray equipment other than those sold by U·C Coatings, use 0.21”/0.55 mm tip or larger
- Logs larger than 24”/60 cm in diameter will require a heavier coating, or two coats must be applied within a 15 minute period
Cleanup & Storage
- Clean application equipment using hot soapy water
- Store unused ANCHORSEAL above 50°F/10°C to prevent freezing. Winterized formulas will protect against freeze damage
ANCHORSEAL Classic - The original log & lumber end grain sealer introduced by U-C Coatings in 1980.
#1 End Sealer For Green Logs and Lumber
Apply ANCHORSEAL to lumber or log ends as quickly as possible after end trimming, to achieve the highest level of protection against end checking and degrade. Improves yield with less waste.
GREAT FOR USE ON
- Hardwood logs and lumber
- Softwood timbers and lumber
- Debarked logs
- Log exports
- Woodturning blanks
- Log "cookies"
Apply immediately after cutting or sawing for the best protection.
Similar in viscosity to latex paint, ANCHORSEAL is easily applied using a brush or sprayer.
Application: Apply as much ANCHORSEAL as the log or lumber will hold, until it begins to drip slightly. If the product does not begin to drip, you may not be applying enough product, which could result in end split
Water-based, Non-hazardous, No Solvents
Clean-Up: Use hot, soapy water to clean equipment. Solvent cleaners are not needed or recommended.
Available in 35 different colors to differentiate your logs & lumber
It is available in clear or 35 different colors, winter & summer formula's. ANCHORSEAL helps reduce blue stain and sapstain in logs.
Share




